DIY M4 Pistol Grip By; Soulman

Here is a nice DIY tip for airsofters who are good with DIY stuff. It is a step by step article about making a DIY airsoft M4 pistol grip out of the stock pistol grip grip that came with the airsoft rifle.

 You'll need a stock pistol grip.

Materials i used are, sanding paper, epoxy clay, epoxy glue, paint.

Remove the grip and wipe off any grease and dirt before applying the mod.

start off by molding the curves, using epoxy steel.

next, fill up the rest of the grip with epoxy clay aqua. aqua has a finer finish and a lot easier to sand than epoxy steel.

after the clays have dried, grind the rough edges with a rotary tool.

sand it down to a fine finish.

this is optional but, since i have an epoxy glue lying around, i applied a thin coat to reinforce the grip.

spray away with a paint color of your choice.